Centrifugal Water Pumps

Centrifugal Water Pumps

In industrial and domestic clean water transportation scenarios, achieving a precise balance between flow rate, head, and energy 

consumption is the core challenge in equipment selection. One company faced problems such as excessive flow leading to energy 

waste and insufficient head affecting water supply stability due to pump type mismatch. To address these pain points, XX brand has

 launched a new series of horizontal integral centrifugal electric pumps, redefining the economy and reliability of clean water transportation

 with three major advantages: "low flow rate, high head; single-phase frequency conversion adaptation; and comprehensive supporting

 services."

I. Core Parameters: Precisely Matching Needs, Rejecting "Oversized Pumps for Undersized Loads"

Dual Flow Rate and Head Standards:

For operating conditions requiring a flow rate of 3 L/s (10.8 m³/h) and a head of 45m, XX brand offers customized models in the CDL-X 

series (such as CDL20-18B). Through optimized impeller design, precise matching of flow rate and head is achieved at 60Hz, avoiding 

energy waste caused by excessive flow.

Lightweight Single-Phase Motor: Utilizes a single-phase asynchronous squirrel-cage motor (230V/60Hz/3600rpm), with power ranging 

from 1.5-3kW, suitable for small-scale clean water transportation scenarios, reducing grid load and installation costs.

Wide Voltage Operating Range: Supports rated voltage fluctuations of ±10% (207-253V), adapting to unstable voltage environments 

and ensuring continuous and stable operation.

II. Full Lifecycle Service: From selection to maintenance, one-stop service.

Intelligent Electrical Control Panel: Standard configuration includes an IP55 protection-rated direct-start control box with built-in circuit

 breakers, contactors, thermal relays, and start/stop buttons. Component specifications are automatically matched according to motor

 power (e.g., a 3kW motor with a CJX2-2510 contactor).

Optional frequency converters are supported for stepless flow regulation, further optimizing energy consumption (e.g., reduced speed 

operation at 3 L/s). Ready-to-use repair kits: Each pump comes with a mechanical seal and bearing repair kit, with the model strictly

 matched to the pump shaft diameter (e.g., Φ40mm), minimizing downtime for maintenance.

Pre-installation of foot valves is provided, ensuring a seamless connection between the suction inlet diameter and the pump body 

(e.g., DN80), avoiding on-site installation errors.

Full technical team support: From the selection stage, performance curves and operating condition simulation reports are provided to 

ensure the pump operates in its high-efficiency range; 72-hour response repair is provided during the after-sales stage, with ample spare

 parts inventory to reduce the risk of production interruptions.

III. Customer Case: 30% Energy Consumption Reduction and Improved Stability: In a hotel water supply system upgrade project, the 

original pump flow rate reached 15 L/s, far exceeding the actual demand (5 L/s), resulting in an increase of 21,000 kWh in annual power

 consumption. After switching to the CIXIFM brand CDL15-12B pump:

Precise flow matching: Flow rate is reduced to 5 L/s through frequency conversion speed regulation, while the head remains stable at 40m;

Significantly reduced energy consumption: Annual electricity savings reach 18,000 kWh, reducing electricity costs by 42%;

Zero maintenance costs: No leaks after 18 months of operation, mechanical seal not replaced.

If you have any questions about industrial pumps, water pumps, or booster pumps, please contact CIXIFM Winny:

Email: [email protected]

WhatsApp: 008618049841995