Micro meter for methanol

Cx-m series small flowmeter is a novel volumetric flowmeter developed to meet the market demand and absorb the overseas excellent technology.Has produced a variety of specifications models and model specifications.It is compact in volume, simple in construction,It is easy to install, convenient to use, and accurate to measure and verify the characteristics of colleges and universities.

It has strong adaptability to the viscosity under test, and there is no requirement for the working pressure change and the front and back and left and right joint sections under test. The total flow rate is small, and the artesian flow can be measured and verified in work.It is very suitable for accurate measurement and verification of various fine total flow in fuel consumption of car, gasoline and diesel in heating furnace, food, chemical raw materials, wine, milk and edible oil bottles.

Micro meter for methanol

Methanol micro flowmeter flowmeter application must pay attention

Attention to installation: as a volumetric flowmeter, the micro flowmeter has a lower regulation on the front and rear right and left joint sections. The basis is no joint section regulation.The turbine flowmeter, as a rate flowmeter, has a relatively high regulation on the front and rear and left and right joint sections, and it is a turbine flowmeter with some diameters. It must be equipped with a relative joint section.Because of the different structure, if the turbine flowmeter is installed in the area too close to the elbow, it is very easy to cause vortex cyclone, which will cause harm to the internal centrifugal impeller, and further endanger the precision of the flowmeter.

The basic principle and characteristics of methanol micro flowmeter

Principle: the components and basic principles of small flow meter, the precise measurement of the small flow meter part of the key by 2 of elliptic gears for each other and chassis (measuring room), oval gear turn every week the parallelism of the measured medium for crescent volume 4 times, under the crescent-shaped volume certain standards of small flow meter, if to the oval gear at a rate of n, can understand the total capacity of the material being tested.After organizing the rotation of the gear according to a series of deceleration and transmission ratio, the gear is immediately connected with the indicator pin on the control panel of the instrument panel, and through the pedal electronic counter to carry out the total output display information.The key to the display information of far transmission is to push the magnet according to the gear after the speed reduction, so as to make the contact point of the slug automobile relay close or break with the same step as the magnet, and then send the electric sparks to another digital display instrument.

Meter model and flow range

CX - M2:0.5 ~ 150 ml/min,

CX - M3:3 ~ 300 ml/min,

CX - M5:5 ~ 1000 ml/min,

CX - M6:0.5 ~ 100 l/H

CX - M9:6 ~ 600 l/H,

CX - M12:0.3 ~ 30 l/min,

CX - M25:0.5 ~ 100 l/Min

Porcelain city professional engineering and customer service team is your professional engineering support and guarantee, if you are special engineering, we can also customized for you, 3~4 weeks to ensure high-quality delivery, customer demand is our product demand, to meet customer demand is the essence of our service.