Quantitative control of sealing strip glass glue pouring flow meter

[email protected]

Quantitative control of sealing strip, glass glue pouring flow meter

Automotive sealing strip trace glass glue flow meter

1. Real Working condition analysis:

Medium: glass glue

Viscosity: very high

Flow: 3-5g/s

Temperature and pressure: normal temperature and normal pressure

Power source: Syringe (injection volume can be set)

Detection method: quantitative addition

Display: need to display, two alarm signals

Specific working conditions: The sealant strip on the car needs to be injected with sealant. Apply glass glue to the sealing strip, and apply 

40 seconds to the tape a day. The purpose is: to apply the amount for 40 seconds, above or below . Equipped with digital display, with upper 

and lower limit holding signal.

2. Industry analysis:

1. Why use a flowmeter:

A. Strictly control the amount of glass glue injected to ensure that the injected glue can well ensure the sealing effect.

B. To monitor whether the flow rate is stable during the glue spraying process, if the flow rate becomes too large or too small with a digital 

display with an alarm signal, it can be found in time;

2. Disadvantages of not using flowmeter:

If it is impossible to find out whether the dispensing amount is the same or whether the dispensing is completed, it will seriously affect the 

sealing quality of the sealing part, which is not conducive to the promotion of the brand effect, and it is impossible to make a high-quality 

product for customers.

If you want to know more about the parameters and quotation of trace glass glue quantitative coating flow meter, please contact winny: [email protected]